Built to Spec.
Cleaned to Match.
Construction ends — but the job isn’t done until the space is genuinely ready for occupancy. Ovaro handles the full post-construction clean, from rough debris removal through final inspection-ready polish, so you can hand over on time and on standard.
Nothing left behind.
Post-construction cleanup requires a different level of attention than standard cleaning. Here’s every element we address before we hand the space back to you.
Construction Dust Removal
Fine drywall and concrete dust settles everywhere — surfaces, vents, fixtures, and inside cabinets. We remove it completely, not just from the obvious places.
Debris & Material Cleanup
Leftover materials, packaging, tape, protective coverings, and construction waste removed and disposed of — leaving a clean slate for occupancy.
Adhesive & Residue Removal
Sticker residue, paint overspray, caulk smears, and adhesive left from protective films removed from floors, glass, fixtures, and hardware.
Window & Glass Cleaning
Interior and exterior glass cleaned streak-free — removing paint spots, construction film, silicone residue, and hard water deposits.
Floor Cleaning & Polish
Hard floors scrubbed, buffed, and polished. Carpet vacuumed and spot treated. Tile grout cleaned of construction residue and sealed where needed.
Fixture & Hardware Detail
Sinks, faucets, light fixtures, door handles, hinges, and switch plates cleaned of fingerprints, dust, and installation residue — shining and ready to use.
Restroom Deep Clean
New restrooms cleaned top to bottom — grout sealed, fixtures polished, and every surface sanitized before first use.
HVAC Vent Cleaning
Vents and registers wiped clean of accumulated construction dust before the system runs — protecting your air quality and HVAC equipment from day one.
Inspection-Ready Final Pass
A complete final walkthrough before handover — every surface, corner, and fixture checked so your space is ready for occupancy inspection or client walkthrough.
Three phases. One standard.
Rough Clean
The first pass after construction wraps. Large debris removed, bulk dust cleared, and surfaces prepped for detail work. Sets the foundation for everything that follows.
Detail Clean
The core of the post-construction process. Every surface, fixture, window, floor, and hidden corner cleaned thoroughly — adhesive removed, dust eliminated, residue gone.
Final Polish
The touch-up pass before inspection or occupancy. A complete walkthrough to ensure every element meets handover standards — because the last impression is the one that matters.
The standard your project deserves.
Deadline-Driven
We work around your project timeline and handover date — not the other way around. When your general contractor needs the space ready, we make sure it is.
Construction Familiar
We know what construction leaves behind. Fine dust in vents, silicone on glass, adhesive on hardware, overspray on floors — we know where to look and how to remove it.
Inspection Ready
Our standard matches occupancy and inspection requirements. Clients and contractors walk through with confidence knowing the space is genuinely ready — not just surface-clean.
Fully Insured
Post-construction environments carry unique risks. We are fully licensed, bonded, and insured for construction site work — protecting your project and your peace of mind.
Ready to open on time?
Tell us about your project — square footage, scope, and your target handover date. We’ll build a post-construction cleaning plan around your timeline. Response within 2 hours.
Get a Free Quote